Comprehensive Guide to Changing Codes on Your Emtek Lock

Understanding the Different Codes in Your Emtek Lock

Before you begin modifying codes on your Emtek electronic lock, it’s essential to familiarize yourself with the two main types of codes it uses: the Programming Code and the User Codes. Each serves a distinct purpose and has specific functions within the lock’s system.

Programming Code: This is a unique 6-digit code that comes preset when you purchase your lock. You will need this code to access the lock’s advanced settings and make changes such as adding or removing user codes. Remember, you have the ability to change this code to enhance your security.

User Codes: These are typically two default 4-digit codes that allow authorized users to lock or unlock the door from outside without needing the Programming Code. You can create, modify, or delete these User Codes at any time to control access for family members, friends, or service providers.

Table of Contents

• How to Change the Programming Code
• How to Modify a User Code
• Testing Your Updated Codes
• Final Tips and Recommendations

Changing the Programming Code

To update the Programming Code on your Emtek lock, follow these detailed steps:

1. Press and hold the EMTEK button on the keypad for approximately 3 seconds until the indicator light responds.
2. Observe the LED indicator; it should flash yellow and then stay solid, while the keypad lights up, signaling readiness.
3. Input your current Programming Code. The LED will flash yellow, followed by a single beep, and then the yellow light will turn solid.
4. Press the number 1 on the keypad to proceed with changing the code.
5. Enter your new 6-digit Programming Code. Ensure it’s unique and secure.
6. Re-enter the new 6-digit code for confirmation.
7. If successful, you’ll see a series of green flashes accompanied by several beeps, indicating the update has been completed successfully.

How to Change a User Code

Modifying an existing User Code involves removing the old code and inputting a new one. Here’s how to do it:

1. Activate the lock by pressing and holding the EMTEK button for about 3 seconds.
2. Wait for the LED to flash yellow and then turn solid, with the keypad illuminated.
3. Input your current Programming Code. The LED will flash yellow, followed by a beep, then turn solid.
4. Press 3 to initiate User Code management mode.
5. Enter the User Code you wish to remove, then re-enter it to confirm deletion. You should see about 4 green flashes and hear 4 beeps, confirming the removal.
6. To add a new User Code, press 2.
7. Input your new 4-digit User Code, then re-enter it for confirmation.
8. Successful addition will be indicated by 4 green flashes and four beeps, signaling the new code is active.

Testing Your New Codes

Once you’ve made changes, it’s crucial to verify their effectiveness:

• Lock your door and attempt to unlock it using the old User Codes. If the door remains locked, the codes have been successfully updated.
• Next, test the new User Codes to ensure they work correctly. If the door unlocks with the new codes, you’ve successfully completed the update.

Note: You cannot modify or change codes without knowing the current Programming Code. If you’ve lost this code, refer to troubleshooting guides on how to regain control of your lock.

Related Articles

• How to Change Code Length on Schlage Encode
• How to Change Code on Brinks Keypad Lock

Final Tips and Security Recommendations

Always remember to change default codes immediately after installation to prevent unauthorized access. Regularly review and update your User Codes to maintain optimal security. If you encounter issues or forget your Programming Code, consult the manufacturer’s support resources or contact a professional locksmith for assistance.